English
Español
Русский
Français
العربية
How can an old battery be disassembled?
The battery is generally composed of four parts: a charger (CHARGER), an inverter (INVERTER), a static switch (SYATICSWITCH), a battery (BATTERY) and a control part. How to remove the old battery? ? How much do you know about this problem? ? Today, the editor of Zhengzhou Kanglida Electronic Power Supply Co., Ltd. will give you some information on this issue. I hope it will be helpful to you. In the future, you can avoid detours when using and purchasing.
1. Confirm the battery installation position. Most models are installed in the engine compartment or luggage compartment, and some models are installed in the cockpit. Take protective measures for the body at the corresponding position.
2. Remove the external protection devices such as the battery guard, use a multimeter to measure the voltage between the two poles, or check the battery status through the observation hole, and explain these conditions to the customer.
How to remove the old battery?
3. If the vehicle is equipped with an anti-theft system (including audio anti-theft), you can connect an external power supply first, or connect a battery with sufficient power in parallel. Note that first connect the positive ji and then the negative ji. The positive ji of the external power supply can be directly connected to the positive ji terminal of the battery, but the negative ji should not be directly connected to the negative ji terminal of the battery, but should be connected to the body ground.
4. Turn off the ignition switch of the faulty vehicle (some models need to be placed in the ON gear, such as Volvo S80 produced before 2005, etc., should be subject to the maintenance manual), first disconnect the negative ji connection line of the battery, and then disconnect the positive ji Connect the line. If the battery has a vent pipe, remove it first.
5. Remove the fixing device of the battery and take out the battery. If the vehicle is connected to an external power source, be careful not to make the positive ji wiring contact the body, and use cotton cloth to isolate it.
The editor reminds that if the old battery leaks and corrodes, it is necessary to clean the battery cable.
Zhengzhou Kanglida Electronic Power Co., Ltd. was established in 2000, specializing in the development, production and sales of 4 series of maintenance-free lead-acid batteries and electronic chargers of 2V, 4V, 6V and 12V. Products are widely used in anti-theft alarm systems, fire alarm systems, building intercom systems, elevator emergency evacuation systems, emergency lights, attendance machines, sprayers, electronic scales, children's electric motorcycles, cartoon inflatables, car washers, table turntables, parking locks, Strobe lights, traffic lights, DC screens, solar energy, wind energy, UPS, EPS and other backup power systems, if you choose a company, you must choose a company with guaranteed reputation and quality. This company has been operating for many years and has many years of experience. Experienced company, so if you need this, you may wish to contact us, I believe it is a good choice.
Message
