English
Español
Русский
Français
العربية
What to pay attention to when forklift lead-acid battery is not in use
For lead-acid batteries, the positive ji is lead dioxide, the negative ji is spongy lead, and the electrolyte is aqueous sulfuric acid. The separator (diaphragm) uses microporous rubber separators, microporous plastic separators or other materials according to different types of lead storage batteries. , The battery shell is made of hard rubber, engineering plastics, glass steel and other materials.
What should I pay attention to when the forklift lead-acid battery is not in use? ? How much do you know about this problem? ? Today, the editor of Zhengzhou Kanglida Electronic Power Supply Co., Ltd. will give you some relevant information on this issue. I hope it will be helpful to you. In the future, you can avoid detours when using and purchasing.
Forklift lead-acid batteries have insufficient power. This situation is usually caused by battery congestion caused by incorrect charging and discharging. At this time, we should stop using the forklift, and connect two of the batteries to the discharge pile to discharge the power, and then plug in Turn on the power and fully charge it.
Forklift lead-acid batteries need to be stored when they are not in use later, to avoid insufficient power when the forklift is used urgently. This tubular lead-acid battery has self-discharge and has strict environmental requirements. Please be careful not to exceed -20°C during storage. ～+40℃ range. It is necessary to store the battery in a charged state. As part of the capacity will be lost due to self-discharge during transportation or during the storage period, please recharge it when using it. If it is left unused for a long time, to make up for the self-discharge during storage, please charge it up. Replenish the power once a month. When stored at a temperature exceeding 40C, it will have a bad effect on the battery life. Please avoid it!
The forklift lead-acid battery has sparks. In this case, you should stop and check immediately, check whether the positive and negative of the battery are reversed, and then wipe the battery with a clean rag. If there are exposed wires, etc., it needs to be replaced immediately. If the cause is not found Need to check and repair immediately.
The lead-acid battery of a forklift truck cannot be charged and the battery is 0. Be careful at this time. Take out the power supply and leave it in the open air for about 1 hour to release the static electricity attached to the original battery. Then try charging. If not, you need a professional The tool opens the battery box, removes the obviously bulging battery, and then connects the remaining batteries in order. In this way we will find that the battery can be charged and used again.
Zhengzhou Kanglida Electronic Power Supply Co., Ltd. specializes in the development, production and sales of four series of 2V, 4V, 6V, 12V maintenance-free lead-acid batteries and their electronic chargers. Products are widely used in anti-theft alarm systems, fire alarm systems, building intercom systems, elevator emergency evacuation systems, emergency lights, attendance machines, sprayers, electronic scales, children's electric motorcycles, cartoon inflatable models, car washers, table turntables, parking locks, Flashing lights, traffic lights, DC screens, solar energy, wind energy, UPS, EPS and other power backup systems. When choosing a company, you must choose a company with guaranteed reputation and quality. We are a company that has been operating for many years and has many years of experience, so if you need it, you may wish to contact us. I believe it is a good choice.
Message
